Well! Thick cable pushes outgoing container with valve bent.

The machine works perfectly fine. it hasn't run very many hours yet, but it looks good so far. Perhaps there is a potential for improvement in terms of the lid above the draft. It is perceived as not very functional, and it fell off in the end.

The machine in question was acquired in the summer. The machine has stripped approx. 5000 kg of cable without problems and quickly. In addition, the copper and insulation of the cables run through the machine easily separate from each other.

Today I unpacked the peeler and went to test what it can do..... The packaging came honestly in plywood, which pleased me because it is 140 kg of iron and I would hate to deal with the claim that it is wrinkled and broken. The build was fairly simple. I am pleased that a 22mm and 17mm flat key was included as well as an Allen key for fixing the knives. You still need a 10mm wrench, but I really own that, so it didn't bother me. Starting the machine itself is very simple, but I warn you right away that you won't be able to do it with some old electrical distribution with a 10A fuse....the motor is not a sharpener after all, so at least 16A without other appliances !!!!! Well, then I just pushed the cable into the hole and a piece of bare wire fell out from the other side....no science. I haven't used the included cutting knives yet, but I only peeled through the rotary rollers.....it has to be adjusted correctly and it was too hot for that today..:-).....one warning though....really don't cook long in there wires... peeling 23m per minute is quite a feat and therefore some eye on the wire could catch you and make you a baby :-).... better meter pieces and flatten a bit so you don't have an accident instead of ducks from the collection point... .

Hello, do they strip 1.5 and 2.5 cables please

Hello, A super effective product with little bulk. Sincerely

The cable does slide quickly through the rollers and it peels very comfortably, but really there are hardly any instructions about the adjustments of the different rollers and the use of long additional blades.. So with the attitude of testing and learning, you should very much go with this device. Otherwise, I have been very satisfied with the machine so far