Multi Process Welder - 250 A - 400 V - MIG/MAG - WIG - E-Hand - FCAW

With a welding current of up to 250 A (MIG), the multi process welder S-MULTI 250M has the right welding method for every metal work. Thin sheets or robust steel beams, with or without gas, on the construction site or in the workshop - with the MIG / MAG, WIG, MMA or FCAW welding methods, you can weld metals efficiently and safely.

At a duty cycle of 60% the welder is powered by up to 250 A for MIG/MAG welding. The power for MIG welding can be regulated down to 194 A and at 200 A you can weld without breaks. For WIG welding and MMA welding, a welding current of 230 A is reached. At a duty cycle of 100% you can weld with 178 A.

The easily readable control panel with 2 LED displays gives you maximum control over the welding parameters and is also easy to operate with welding gloves. You can seamlessly adjust the current and voltage (MIG), determine the inductivity, switch between a 2-step or 4-step operation, regulate the gas delay time and the current increase and decrease and choose the welding method.

• Effortless change between MIG / MAG, TIG, E-Hand, FCAW welding processes
• Versatile for metalwork on construction sites or in the workshop
• Clear control panel with 2 LED displays
• Easy switch between 2-step and 4-step operation
• Suitable for a wide variety of metals, depending on the welding method
• Supply of welding wire via the standard feed with four wire rolls or a spool gun directly at the burner
• Wire feed speed adjustable on the device

The welder has an undercarriage, which makes it particularly easy to transport. Two handles allow you to pull the device easily on its sturdy rubber wheels to its destination. There is enough space for a gas cylinder above the large rear wheels. It is secured with a bracket and two chains.

For MIG / MAG welding, the welding seam is protected with gas. The MIG uses inert gases and the MAG uses active gases. It is characterized by high welding quality, efficiency and welding speed. It is universally applicable, well suited for welding steel structures as well as for smaller welding jobs.

For MIG / MAG welding, the inductivity is adjusted between wide and narrow via a switch. The exact value can then be set on a rotary control. This smooths the welding current and significantly improves the welding quality. For MIG welding, you can use a spool gun (not included in delivery), where the cored wire is fed directly to the torch.

WIG welding with the S-MULTI 250M uses the high-frequency ignition to activate the arc. It is suitable for most metals and can be used from a metal thickness of 0.5 mm. The burner welds with little sparks and splashes, producing weld seams of high quality and purity with hardly any deformation. The welding parameters are easily controlled via the control panel. You can weld from different positions, be it vertical, horizontal or overhead.

• Professional high-frequency ignition
• Gas post-flow time seamlessly variable
• Optimized current increase and decrease time prevents damage to the weld
• Also suitable for thin metals from 0.5 mm
• Hardly any sparks, slags or post-processing